How to Iron on your Letters

Please follow the steps below for a perfect application

You can use a standard household iron or a commercial heat press to apply your iron on letter transfers. If you get stuck, please reach out to us - we're more than happy to help!

Step 1

Remove your iron on names from the envelope

Once your order arrives, remove the transfers. Be sure to check the envelope fully as some transfers can sometimes get stuck.

Step 2

Cut the iron on names into singular items

Transfers in the same colour are often sent on the same sheet, you can use standard scissors to cut the transfers into individual items.

Step 3

Place your iron on name down on your garment

Place your iron on letters down on your garment (which should be on a hard flat surface ie. table) in the order you require.

All transfers are mirrored so place them down so they look correctly when viewing the garment.

Step 4

Cover the iron on name with clean white paper

Place a piece of white clean paper over the transfers ensuring that your transfers do not move whilst ironing.

Step 5

Use an iron to apply your iron on name

Do not Use Steam

All materials are different, and therefore we advise to set your iron at a low temperature first - then follow the rest of the instructions. If the transfers have not fully attached, increase the temperature slightly and repeat until the transfers have stuck correctly - do not exceed the cotton 1 pre-set.

If the plastic carrier is melting your temperature is far too high - please turn down your iron.

Press the iron firmly onto the transfers ensuring you do not move the iron.

Do this for between 15-30 seconds.

Step 6

Remove the paper and peel back the transfer plastic backing

Remove the paper, and leave to cool for 5-10 seconds.

Slowly peel back the plastic leaving your iron-on transfers in place. If the transfers begin to peel then re-iron for longer and use more pressure.

Step 7

Re-Press the Iron on Name

This step is optional. If your transfers look a little bumpy, then take the piece of white paper, cover the transfers again, and iron normally using a good firm pressure.

Complete!

Iron on name Successfully Applied

Congratulations! Your transfers have been applied successfully 😍